How a Swiss pool is ranked
In a pre-drawn Swiss pool the teams do not all play each other. In a pool of six teams over four rounds, each team misses one of the other five; in a pool of ten over four rounds, each misses five. Two teams can finish on the same points after very different days, so the pool needs a couple of rules that a group where everyone plays everyone does not.
This page walks through the order FairGame uses, one step at a time, with an example taken from a real youth tournament. Only the team names have been changed.
It applies to pre-drawn Swiss pools. An adaptive pool, drawn round by round from the results, follows the same steps, with each team's skill rating in place of opponents' points — see adaptive pools.
The order
In football, teams are compared on these steps, from the top. The first step that separates two teams decides, and the steps below it are not looked at.
- Points — 3 for a win, 1 for a draw, 0 for a loss.
- Goal difference — goals scored minus goals conceded.
- Goals scored.
- Wins.
- Head-to-head — the result of the match between the two teams, if exactly two are level and they played each other.
- Opponents’ points — the points of every team they have played, added up.
- Opponents’ goal difference — the goal difference of every team they have played, added up.
If teams are level on all seven, they share the place.
This follows the UEFA league phase, the Swiss format the Champions League plays, and keeps the KSÍ and Rey Cup order of a football group for the first steps. It differs from a group in three ways that come from not everyone playing everyone:
- Wins come before head-to-head.
- Head-to-head counts only between two teams that met. If they never played each other, the step is skipped.
- There is no mini-table. In a group, three or more teams level on everything are separated by a table of only the matches among them. In a Swiss pool those teams have not necessarily all met, so that table would not be fair. The strength of each team's schedule takes its place: opponents’ points, then opponents’ goal difference.
Your tournament's own order applies. If you chose a different order under Settings → Schedule & format → Tiebreakers — for example Head-to-head first — a Swiss pool follows it too, without the mini-table and with opponents’ points and opponents’ goal difference added at the end. If your order already places opponents’ points, they count where you put them, and opponents’ goal difference still comes last. Other sports use their own steps, followed by the same two, listed on standings and tiebreakers.
Under every Swiss table the public site names the order it used.
What opponents’ points are
Take every team your team has played, look up how many points each of them has right now, and add them up. A team you played twice counts twice. A round where your team had no match (a bye) adds nothing.
The idea is that nine points earned against the strongest teams in the pool is a better result than nine points earned against the weakest. Opponents’ points reward the harder schedule — but only between teams that are level on everything the matches themselves can show.
On the public site and in the admin tables the figure is in the SOS column (for strength of schedule). In the FairGame app it is shown under each team's name as Opponents’ points. Chess players will know the same idea as the Buchholz score.
Because the figure uses each opponent's points right now, it keeps moving until the pool is finished, and correcting a result anywhere in the pool changes it. That can only reorder teams that are level on points, goal difference and goals scored.
Example: a pool of six
Six teams, four rounds each. Wolves 1 and Wolves 2 are from the same club, and the draw keeps clubmates apart, so they never met.
| Match | Score |
|---|---|
| Wolves 2 – Foxes | 1–4 |
| Wolves 1 – Ravens | 1–3 |
| Bears – Owls | 0–4 |
| Wolves 1 – Bears | 0–3 |
| Bears – Foxes | 2–3 |
| Ravens – Wolves 2 | 3–1 |
| Ravens – Foxes | 0–1 |
| Bears – Wolves 2 | 7–0 |
| Owls – Wolves 1 | 0–1 |
| Owls – Ravens | 1–2 |
| Owls – Wolves 2 | 8–1 |
| Foxes – Wolves 1 | 0–2 |
The final table:
| # | Team | Won–drawn–lost | Goals | Goal difference | Points | Opponents’ points |
|---|---|---|---|---|---|---|
| 1 | Ravens | 3–0–1 | 8–4 | +4 | 9 | 21 |
| 2 | Foxes | 3–0–1 | 8–5 | +3 | 9 | 21 |
| 3 | Owls | 2–0–2 | 13–4 | +9 | 6 | 21 |
| 4 | Bears | 2–0–2 | 12–7 | +5 | 6 | 21 |
| 5 | Wolves 1 | 2–0–2 | 4–6 | −2 | 6 | 30 |
| 6 | Wolves 2 | 0–0–4 | 3–22 | −19 | 0 | 30 |
First place: goal difference, not the match between them
Ravens and Foxes both have 9 points. Goal difference decides: Ravens +4, Foxes +3, so Ravens win the pool by a single goal.
Foxes beat Ravens 1–0 when they met, but head-to-head comes after goal difference and goals scored, exactly as in any football group under KSÍ rules. It would only have decided if the two had also been level on both. If your competition's rules put head-to-head first, choose Head-to-head first under Settings → Schedule & format → Tiebreakers, and Foxes would be first.
This is the result coaches most often ask about, so it is worth explaining before the tournament starts.
Third to fifth: goal difference again
Owls, Bears and Wolves 1 all have 6 points. Goal difference puts them in order: Owls +9, Bears +5, Wolves 1 −2. Opponents’ points are never reached.
When opponents’ points decide
Only when teams are level on points, goal difference, goals scored and wins, and head-to-head cannot separate them — because they never met, or because more than two teams are level.
Say two teams in a pool both finish on 6 points with a goal difference of +2, 7 goals scored and two wins, and they never played each other. The teams the first one played have 21 points between them; the second one's opponents have 15. The first team goes above: it earned the same record against a harder schedule.
If their opponents' points are level too, opponents' goal difference decides the same way.
Why opponents’ points come after the match steps
In a big pool, where each team misses most of the field, opponents’ points say a lot about how hard a team's day was. In a small pool they say very little. When every team misses exactly one opponent — six teams over four rounds, eight over six — there is a shortcut:
opponents’ points = every point in the pool − your own points − the points of the team you did not play
In the example the pool holds 36 points in total (9 + 9 + 6 + 6 + 6 + 0):
- Wolves 1: 36 − 6 − 0 (missed Wolves 2) = 30
- Owls: 36 − 6 − 9 (missed Foxes) = 21
- Bears: 36 − 6 − 9 (missed Ravens) = 21
So between two teams on the same points, opponents’ points only measure which team each of them missed — and the draw decides that, not the teams. Wolves 1 got 30 because the draw kept it away from its clubmate Wolves 2, who lost every match. Ranking opponents’ points before goal difference would have put Wolves 1 third, above two teams with far better results on the pitch.
That is why opponents’ points settle only what the matches cannot.
Putting opponents’ points first
Some competitions rank a Swiss pool the chess way: of two teams on the same points, the one that met the stronger opponents goes ahead. Choose Opponents’ points first under Settings → Schedule & format → Tiebreakers and the order becomes points → opponents’ points → goal difference → goals scored → wins → head-to-head → opponents’ goal difference. Or tick Opponents’ points in a Custom order and move it to where your rules put it.
It suits a big pool, where each team misses most of the field. In a small pool, as the example above shows, opponents’ points mostly measure which team the draw kept each team away from.
Only Swiss pools count opponents’ points; a group where everyone plays everyone skips them. In an adaptive pool the skill rating takes their place.
Level on everything
Teams that are level on every step share the place. Two teams level for second are both shown as 2nd, and the next team is 4th. Neither the alphabet nor the order you entered the teams in decides it.
If the shared place is first, the pool has two winners: the overview names a shared title.
When the pool is finished
Until every match in the pool has a result, the note under the table reads Current standing. Once the last result is in, it reads Final standing. An adaptive pool is finished when its last planned round has been played too.
For a category played as one Swiss pool with no knockout after it, the finished table is the result:
- The champion appears on the Overview of the public site and in the control room.
- Every team's final place appears on the category's page.
Correcting a result after that updates the table, the places and the champion.
Adaptive pools
An adaptive pool is ranked the same way, points first. In place of opponents' points it uses each team's skill rating, shown in the Skill column. Each round pairs teams of similar skill, so two teams on the same points may have met very different opposition, and the rating weighs every result by the strength of the opponent. It never puts a team above one with more points.
Tips for organizers
- Tell coaches the order before the first match. Link them to this page; the note under each Swiss table on the public site lists it too. The question "we beat them, why are we below them?" is far easier to answer before the tournament than during it.
- Choose the order your rules say. If your competition decides ties by head-to-head first, or by opponents’ points first as in chess, set it under Settings → Schedule & format → Tiebreakers; Swiss pools follow it.
- Check a correction's knock-on effect. After fixing a score, look at the whole pool's table, not just the two teams that played.
- Consider not publishing a table for young age groups. Many youth tournaments play Swiss pools so that every team gets even matches, not to crown anyone. You can publish fixtures and results without a table.
- Keep blowouts out of the goal difference. Goal difference also rewards an easy draw: a 7–0 against the weakest team counts in full. If your rules say goals beyond a margin do not count, count the published-margin cap in the standings.